Getting Started

Start here

🚨Read this first🚨

There are some important things about the nRF9160 Feather before you get started:

  1. The nRF9160 Feater shouldn't be used with a battery less than 300mAH. More information in the specs section.
  2. If you need to debug your nRF9160 Feather, it requires an external programmer. More information on that in the Requirements for external programming section.
  3. If you're new to Zephyr, be sure to check out the Zephyr 101 series on Youtube!
  4. Looking for help? Check out the support forum: https://community.jaredwolff.com

What's included

nRF9160 Feather

  • 1x nRF9160 Feather board
  • 1x set of male headers (16 pin and 12 pin)
  • 1x getting started card
  • 1x IoT SIM

SDK and Development Environment Setup

Instructions below are based on using Microsoft's Visual Studio Code as your workspace. While you may choose a different editor, most of the steps remain the same.

Getting Started Sections